Skip to content

Knowledge Base

Joining your Bedrock server

Not every Bedrock Edition platform can join custom servers directly. Pick the method for your device below. You will need your server address and port from the Zettako Panel.


Windows and mobile devices

  1. Open the Servers tab and click Add Server.
  2. Enter a server name, your server address and your port.
  3. Press Save, then Play.

Xbox and Nintendo Switch

These use the public GeyserConnect server. There are two ways to use it.

Method 1: change your DNS (recommended)

  1. Open your DNS settings:
    • Xbox: Settings › General › Network settings › Advanced settings › DNS settings
    • Switch: Settings › Internet › Internet Settings › your Wi-Fi connection › Change Settings › DNS Settings
  2. Set the primary IPv4 DNS to 44.193.156.219.
  3. Set the secondary IPv4 DNS to 1.1.1.1, 8.8.8.8 or your gateway IP.
  4. Join any official server in the Servers tab.
  5. You can now enter your server address and port from the panel.

This may not work if IPv6 is enabled on your network. Either turn IPv6 off in your router, or use the friends list method below.

Method 2: friends list

  1. Go to your friends list and select Add Friend.
  2. Type Public GC as the gamertag. You can use Public EU GC or Public US GC instead.
  3. Select Add Friend and wait for the bot to add you back.
  4. Go to the Friends tab in your game, find Public GeyserConnect proxy and join it.
  5. You can now enter your server address and port from the panel.

You can add and remove the bot as often as you like. The DNS method is recommended because each bot can only have a limited number of friends at once.

Please rate this article to help us improve our Knowledge Base.

1 0